8/10/2023 0 Comments Flux 125 welder guide![]() Shop Lighting Options: Choosing the Right Kind for Your Shop June 11, 2022.Since 10 gauge steel is a little thicker than 1/8″, I choose to start off with the voltage at F.5 and a wire speed of six. To get the welder set for 10 gauge steel, I refer to the chart on the inside of the welder top. I turn on the welder, making sure the flux gun is not in contact with table. ![]() I clamp my first piece to the table, then put the ground clamp on the edge of the table.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |